Midland Industries 12104 – Straight Adapter, 7/16″ Inverted Flared x 1/4″ Male NPTF, Brass

Midland Industries 12104 Straight Adapter, 7/16 in Inverted Flared x 1/4″ Male NPTF, Brass

SKU: 12104
Additional Information	0.032 in Tube Wall Thickness
Connection Size 1	7/16 in
Connection Size 2	1/4 in
Connection Type	Inverted Flared|MNPT
Connection Type 1	Inverted Flared
Connection Type 2	Male NPTF
Dimensions	1.05 in L
Fitting Type	Adapter
For Use With	Aluminum, Brass, Copper, Steel Hydraulic Tubing That Can Be Flared
Hex Size	0.81 in
Material	Brass
Material Construction	Brass
Pressure Rating	750 psi
Temperature Rating	-65 to 250 deg F
Thread Size	11/16-18 x 1/4-18

Features:

•Typical Application: Hydraulic brake, power steering, fuel lines and transmission cooler lines, LP and natural gas.
•Working Pressure Ranges: Temperature and type of tubing used are important factors. However, the following table is a good guide for proper selection.

• Tolerance: +/- .03 on all dimensions.

• Approvals: Meets functional requirements of SAE J530, J531
•Vibration: Excellent resistance.
•Temperature Range: -650F to +2500F (-530C to +1210C) range at maximum operating pressures.
•Used With: Copper, brass, aluminum and steel hydraulic tubing that can be flared.
•Advantages: Very low cost and reusable. Seats and threads are internal and protected. Compact, excellent vibration life. Short nut affords very close tube bends. Steel or brass tube nut.

Assembly Instructions:
1-Cut tubing to desired length. Make sure all burrs are removed
and the ends are cut square.
2- Slide nut on tube. Threaded end “A” of nut must face out.
3- Flare end of tube with a 450 flaring tool.
a- Measure flare diameter.
b- Examine flare for excessive thin out.
c- On thin wall, welded or brazed tubing, use double flare to
prevent pinch-off and cracked flares.
4- Lubricate threads and assemble to fitting body. Nut should
be turned hand tight.
5- Tighten assembly with wrench until a solid feeling is encountered.
From that point, apply a one-sixth turn.
Note: Do not over-torque as it may damage the fitting or split
the tubing at the flare.