iVac Pro Switch; 240Vac; 20A

iVAC Automated Dust Collection – Switch (For Your Dust Collector)

Automated Dust Control for your Safety & Convenience. Used as a component of the iVAC Pro System. The iVAC Pro Switch modules are used to automatically turn on your Dust Collector or Shop Vac when you turn on a power tool plugged into an iVAC Pro Tool module such as a table saw, mitre saw, sander, etc. The dust collector will be connected to an iVAC Pro Switch module.

Features

Three Modes of operation. Auto – Off – On

Four System addresses. Programmable

Turn On Delay

Turn Off Time – Programmable

Master Reset

Specification

Voltage is 240Vac

Current capacity is 20Amps

Circuit breaker is rated at 20Amps

Typical Motor drive capability
2HP at 240Vac

Input power cord is 30” with the respective NEMA straight blade plug

Output power receptacle is the respective NEMA straight blade receptacle

Turn ON Delay 0 or 1.5 seconds

Turn Off Time 0, 5, 15 or 45seconds

Range, 40’ line of sight

Maximum ambient operating temperature, 30C

Regulatory approval
TUV certification to UL60950-1 and CSA 60950-

We strongly recommend the use of the for dust collectors operating on 115Vac rated over 1HP and for any dust collector over 1.5HP operating on 230Vac.